Comparison of Signal Losses in Fibre Optic Cables
DOI: 10.23977/ofsc.2019.11001 | Downloads: 23 | Views: 4267
Igwele Minabai Maneke 1, Ogobiri Godwin Ebikabowei 1, Achor Mathias 2
1 Department of Physics, Faculty of Science, Niger Delta University, Bayelsa State, Nigeria
2 Department of Science Laboratory Technology, Federal Polytechnic, Idah, Kogi State, Nigeria
Corresponding AuthorIgwele Minabai Maneke
In this paper, a direct comparison of signal loss on a network arising from both vibration and non – vibration source using the Anritsu Optical Time Domain Reflectometer (OTDR) has been made. The vibration was generated through a flask shaker, generator and heavy duty truck, which aims at ascertaining the effect of vibration on the network and the need to shield the network from vibration as much as possible. The results of this study was able to show that even in the absence of presumed vibration, a network of this kind can still experience signal losses, but greater losses are most likely to be recorded in the presence of a deliberate generation of vibration on the network. Hence; from this study, the OTDR has been used to acquire these signal losses on the optical fibre cable used for the network for the both cases above and at the end, an overall end – to – end loss of 3.90dB for both cases were observed and a reflected loss of -33.31dB and -33.34dB was obtained for both the non – vibration and vibration source respectively.
KEYWORDSVibration, Signal Loss, Network, OTDR, Optical Fibre, Cable
CITE THIS PAPER
Igwele Minabai Maneke, Ogobiri Godwin Ebikabowei and Achor Mathias, Comparison of Signal Losses in Fibre Optic Cables, Optical Fiber Sensor and Communication (2019) 1: 1-9. DOI: http://dx.doi.org/10.23977/ofsc.2019.11001.
 Igwele, M. M. and Ogobiri, E. G., (2018), Measurement of Signal Losses in Optical Fibre Cables under Vibration Using Optical Time-Domain Reflectometer (OTDR), International Journal of Scientific and Engineering Research, Volume 9, Issue 7, July-2018, pp. 1547–1552, ISSN 2229-5518.
 Anusha M., Abi W., et al., Loss Analysis in Optical Fiber Transmission, SIR SYED UNIVERSITY RESEARCH JOURNAL OF ENGINEERING AND TECHNOLOGY, VOLUME 5, ISSUE 1, 2015.
 Elebi, M. C., Real-time seismic monitoring of the New Cape Girardeau Bridge and preliminary analyses of recorded data: an overview, Earthquake Spectra 22, pp. 609–630, 2006.
 Gholamzadeh, B. and Nabovati, H., (2008), Fiber Optic Sensors, World Academy of Science, Engineering and Technology, Vol. 18, pp 297-307.
 Glišić, B., Inaudi, D., (2007), Fibre Optic Methods for Structural Health Monitoring. [online]. ISBN 978-0470-06142-8.
 Mahmudah S. G., Edi P., et al., Vibration Measurement of Mathematical Pendulum based on Macrobending – Fiber Optic Sensor as a Model of Bridge Structural Health Monitoring, 2016.
 Sensors 2016, 16, 1164; a review, www.mdpi.com/journal/sensors).
 Sharma, R., Rohilla, R., Sharma, M., and Manjunath, T. C., Design and Simulation of Optical Fiber Bragg Grating Pressure Sensor for Minimum Attenuation Criteria, Journal of Theoretical and Applied Information Technology, vol. 5, no. 5, pp. 515-530, 2009.
 Taylor B. and Dr. La Rosa, Optical Fibers: History, Structure and the Weakly Guided Solution, Journal of Physics, 464 Portland State University (May 30, 2008).
 Thyagarajan, K., Ghatak, A. K., (2007), Fiber Optic Essentials. Wiley-Interscience, 2007. 242 p. ISBN 978-0-470-09742-7.
 Van Leeuwen, K. A. H. and Nijnuis H. T., Measurement of higher-order mode attenuation in single-mode fibers: effective cutoff wavelength, Optics letters, Volume 9, Issue 6, pp.252-254.
 Wenzel, H., (2009), Health Monitoring of Bridges. John Wiley & Sons, Ltd. 2009. 643 pp. ISBN 978-0-470-03173-5.
 Zendehnam, A., Mirzaei, M., Farashiani A. and Horabadi F. L., Investigation of bending loss in a single-mode optical fiber, Vol. 74, No. 4, journal of April 2010 physics pp. 591(603).